Writing frequency adjustment value of Jumper T16 or JP4IN1 in the firmware.
When the binding information was copied from JUMPER JP4IN1 installed in the Frsky Taranis X-lite Pro to the Jumper T16Pro V2 as in the previous article, the binding was unstable due to the frequency variation. I can improve it by adjusting the frequency, but when the adjustment value is displayed on the setting page, I feel uncomfortable. Also, I feel that I have to make adjustments for each receiver, so the number of models increases.
So, I set the frequency adjustment value to a value that works well with all the receivers I have. Since the frequency adjustment value is written in the firmware, the display of the frequency adjustment value is left at zero.
I don't recommend this method because it's a matter of taste, but I decided to write it as an article this time because I wanted to record it as my own procedure memo. So let's write the procedure from now on.
We use it on both Mac and Windows, but the USB serial driver is already installed with the flight controller connection. So I didn't install additional drivers. If it is not installed, you need to install it.
